Answer Posted / banambar pradhan
ANS- IF PER RUNNING METER IT IS D2/162KG/M, IF IN VOLUME
i.e7850kg/m3
EX-SUPPOSE DIA OF ROD 12MM AND LENGTH OF ROD 2METER,
CALCULATE THE WT OF ROD.
ANS-D2/162=12^2/162=0.8889KG/M, HERE 2M LENGTH SO
2*0.8889=1.778KG
| Is This Answer Correct ? | 36 Yes | 5 No |
Post New Answer View All Answers
How to compute minimum number of columns required for a site from area of site?
how much repeitation for conventional and maivan formwork?
WHAT DLC DESIGN IN CONSTRUCTION
suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?
use ofr concrete as per grade ?
How to calculate the area of a irregular sized land in square feet?and what will be the total area of this land South-51.1ft , North-47.7ft , East-53.3ft , West-54ft ?please explain me how to calculate?
is there any influence of water(used for mixing of concrete) on a weight of harndend concrete.
If 40 backlogs are cleared m finally with 65 percent marks . Am I eligible to get visa to US
Can anyone suggest how to determine scheduling of reinforcement of floor beams from Staad model,other than clicking each beam respectively 7 noting down the values ?
Please tell me the quantity of cement, sand, flyash, foaming agent required for 1 cubic meter of cellular lightweight concrete blocks. also , is there any admixtures required for the CLC blocks production.
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream
A super elevation of 60 cm has been provided on a 8m wide road and a curve of 260m radius .calculate the max.speed in km/hr of the vehicle that can be negotiated safely? Plz answer with full solution.thanx
Design a shear wall of length 4.20 m and thickness of 250mm subjected to the following forces.Assume Fck = 25Mpa and Fy = 415Mpa and the wall is a high wall with central part 3440mm x 250mm and two 380mm x 760mm strong bands at each end with following loading. S.No. Loading Axial force Moment Shear 1 DL+LL 1950 600 20 2 Seismic load 250 4800 700
Explain the importance of moment of inertia?
What is the diff between cad & cadd?
