line vltage of three phase distribution transformer is 433v
and phase voltage is 250v,but we required 230v for domestic
distribution,then how we reduce phase voltage of
transformer
Answer Posted / farhan shaikh
we use individual phase for 230v AC for eg R or Y or B Phase
Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
What is “pu” in electrical engineering?
what is R Core Transformer. how it differs from normal transformers. dont search in net and post the answer.
how to failure indution motor insulation & how to improve heat in motor insulation
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
how we explain parallel paths armature winding?
In Power cable specification what is U0/U and Um.
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
Why is a plain induction motor unsuitable for wide speed control?
Battery is a voltage source? give one example of current source and why?
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
what is upper impedance and lower impedance of a distance relay