why we use +ve load distribution in 24v , and -ve load
distribution in 48volt.?
- 1 Answers
- 3087 Views
- I also Faced
- E-Mail Answers
Answer Posted / marimuthuraj
Telecom typically passes voice signals. If we used AC to
power the voice line, the AC would impose an audible hum,
which would disrupt communications. It would be really
irritating to listen to as well!
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
Guroscope works on the basis of what?
Define what is the main factor for controlling the thermal generation and recombination?
What is a high-pass filter?
Explain why vestigial side band is used in tv signal transmission?
What is instrumentation amplifier (ia) and what are all the advantages?
Why does a pure semiconductor behave like an insulator at absolute zero temperature?
i completed my b.tech.i want to prepare for civils. when new batch classes will start at rc reddy. plz mail me rajesh.mc28@gmail.com
what is limitation of auto transformer?
A FIU19(E) units Flexbus LED is flashing. What is the meaning?
What is the difference between the bandwidth of half duplex and simplex transmission?
Explain is rfid in developing stage?
What is a transducer and transponder?
what is the role of electronics,communication engg. in IT industry?
"11101111" when that bit oriented message transmitting from sender to receiver.how is it calculate parity bit and how is it show bit stream that would be transmitted..by even parity error detection scheme..pls send me an answer..very important,,
why qpsk is done for 45 135225315 not 0 90.270 360 degrees "degrees why "
