Interested to Buy Any Domain ? << Click Here >> for more details...
you have an automatic voltage regulator at home for your
appliances,if the voltage in your area drops from 220v to
190v,does the output of the automatic voltage regulator
drops?or does it retains the 220v output?
- 4 Answers
- 6917 Views
- I also Faced
- E-Mail Answers
Answer Posted / satish kumar dhiman
No the output voltage will not drop but we have to check
the AVR range to control the voltage.
as AVR work on referance voltage produced by another
transformer or device.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
How is the speed of a DC shunt motor related to the armature current?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?
How to back charge the Gas turbine generator
what is the difference between the voltage of 5 volts capacitor and and 5volts battery?
Define unilateral circuit?
What is phase cross over frequency?
What is the basis for framing the rules of block diagram reduction technique?
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
