Interested to Buy Any Domain ? << Click Here >> for more details...
We have three 33kv substations. All of them energised by
same source.When i am checking the phase sequence between
one substation to other substation
(like R Phase to R Phase) by multimeter i am getting
some voltage.Near to LT panels UPS panels are there. Can u
explain whether any possible to happen
like that. In Phase SEquencemeter is showing correctly
in both substations. How is it happen. Explain me.Explain
me communication signal will produce
Phase difference on this case.
- 3 Answers
- 6114 Views
- I also Faced
- E-Mail Answers
Answer Posted / ee_moorthy
Hi Friend I am used multimeter to measure the voltage
between R Phase(SS1) to R Phase(SS2). In SS1 is connected
with UPS loads. But I am getting voltage between these 2 R
Phases. Please give some idea friend
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
What is the problem of internal failure in ship engine telegraph system norcontrol?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
I Want randstand placement papers
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
why on delay timer used for fully automatic star delta starter?
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
I have 2500KVA transformer delta/star,13.8KV/380V provided with LV 4000A breaker. Already I have 2300KW motor feeder with a full load 90%. Is it possible to connect another 1600A from that breaker? If so how the calculation is done?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.
how to calculate transformer turn primary & secondary side 11kv to 420v
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
design a 3 bit synchronous and asynchronous counter using T- flipflop
