Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / alfred t jose
4-20ma is the standard value,because any small changes
occurs we can simply identify when we use 4-20ma. if any
zero error occur we can identify it by using 4-20ma.
according to pneumatic 3-15psi is used.same reson for that.
when 4ma applied corresponding 3psi optain and 20ma is
applied then we get 15psi.
| Is This Answer Correct ? | 6 Yes | 12 No |
Post New Answer View All Answers
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is rang ability?
please send the sample qustion paper for iocl written test ..
How to fix back the valve actuator stem
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
How to Calibrate Ultrasonic Level Transmitter in field
what is cems analyzer explain with principle and drawing ?
wich is coming the first HAZOP OR SIL
Positioner usage.
what is function of switch, and how is it work, explain with difination
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
