Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / electrix
When High voltage passes through bare conductor. The
voltage ionises the air around its circumference. This
causes the hissing noise and the same is called corona
effect.
| Is This Answer Correct ? | 18 Yes | 0 No |
Post New Answer View All Answers
Do u know any one? how to find out in motor rated amps? formula?
difference between ac series and parallel circuit
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
How many types of protection relays are there based on the characteristic?
what is meant by 3rd hormonics ?
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
RESPECCTED SIR/MADAM- I AM PRERING FOR SECTION ENGINEER (ELECTRICAL) RRB CHANDIGARH PLEASE SEND ME SOME PREVIOUS YEAR QUESTION PAPER OR MODEL PAPER.MY EXAM IS ON (30- NOVEMBER 2008).I AM VERY THANKFUL TO YOU. FROM- HARENDRA SINGH YADAV
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
how choose conductor&depending upon load
What is the application of Dyn1 and Dyn11 vector group of transformer?
What are the disadvantages of thermal power plant?
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
