Answer Posted / guest
kvar denotes the units of reactive power and it is given by
Q=V*V/X
where v denotes voltage and x denotes capacitive reactance
and capacitive reactance is given by
x=1/(2*pi*f*c)
f=frequency and pi=22/7 and c= capacitance for which unit
is farad
| Is This Answer Correct ? | 10 Yes | 5 No |
Post New Answer View All Answers
Define the term factor of inertia.
What is line resistance of cable & how it can be measured ?
what is buffer resistance starter.?.What is the working principle and where it is used..?
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
What is an order of a system.
WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE
what is ATS & RING MAIN UNIT in Distribution System?And its Function.
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
Explain RLC circuit?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
what is KSR type transmission tower? What is LSR type transmission tower?
What are different types of control systems?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
What is grid collapse? what is the reason for it?
