Interested to Buy Any Domain ? << Click Here >> for more details...
How many input terminal of single phase transformer.which
is use for rural power distribution.
- 1 Answers
- 5490 Views
- RMSI, I also Faced
- E-Mail Answers
Answer Posted / revathi
single phase transformer has 2 windings, primary &
secondary. in this primary is the input terminal, it has
phase and neutral.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
why to use freewheeling diode ( diode in revers bias mode) across dc coil
in conventional fan regulators how the current varies with speed?
what is the acceptable limit value for Desolve Gas Analysis/
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
What is open delta Xformer? It's adavntages & Use?
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
why output is out of phase in case of common emitter?
what is the difference between an alternator and a synchronous motor
typically in power distribution substation. 1- Any idea how would be the graph of capacitor bank consumption verses time through the day . 2- How is the switching ( on and off ) of the capacitor bank, per need?
The series field winding has low resistance while the shunt field winding has high resistance. Why?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
I want to put this query to SENIOR & EXPERIENCED ELECTRICAL ENGINEERS. 1)I want to know about the control circuit diagrams for control panels. I found it difficult to understand. Is there ant booklet through which we can learn the circuit diagrams? 2)I want to learn about conduiting, laying cables, preparing cable schedules and various techniques which is the part of building infrastucture(construction field). I don't have any experience in this area. I have experience in control panels only. that's why i am not getting any opening in building infrastucture (construction field).Can I get the job in this field as Trainee Engineer? How to enter this field? I need job in PUNE
1hp= how much rpm
Usage of flywheel diode in relays
physical identification of HT & LT panel
