Interested to Buy Any Domain ? << Click Here >> for more details...
why autotransformers are not safe for supplying low voltage
from a high voltage source?
- 5 Answers
- 14423 Views
- I also Faced
- E-Mail Answers
Answer Posted / gourav bapna
autotransformer is a single winding transformer with unity
ratio.that implies a 1:1 ratio which cannot step up voltage
from a low voltage source.
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
What are test signals and their significance?
how to calculate fault level?
What are n circles?
I need model question papers for RRB section engineer Chennai... Please send to my E-mail Id:- maitheerainbow@gmail.com
How can we measure the residual voltage in dc machines?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
EXPLAIN THE WORKING OF SERIES REACTOR IN HT CAPACITOR BANKS (FOR VOLTAGES & CURRENTS)
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
EXPLAIN THE ESSENTIAL FACTORS WHICH INFLUENCES THE CHOICE OF SITE FOR A HYDRO ELECTRIC POWER PLANT
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
