Interested to Buy Any Domain ? << Click Here >> for more details...
how many minutes or seconds taken by the transmission of
electrical power from generating end to distributing end?
- 3 Answers
- 6163 Views
- I also Faced
- E-Mail Answers
Answer Posted / madan kumar
exactly 5.32seconds. if you have any doubt calibrate the
stop watch.
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
what are the difference between AC lamp and DC lamp
standard earthing rating for power line..
What is the RME and explain the full form and what is the RME work?
how to enter inverter parameter? without manaual?
What is the function of under voltage release ?
what is W.T?specify the acceptable range?
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
how to calculate the conductor size for certain KV transmission line and distribution line?
