Answer Posted / suraj

There are Two basic mode ON/OFF mode and PID control.
but in PID mode there are also three mode
ONE MODE
P=proportional
D=derivative
I=intrgral
TWO MODE
PI=proportional+derivative
THREE MODE
PID=proportional derivative intrgral

why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?

2055

---

I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration  So is there any causes biside this or  any  permissives ?

1855

---

please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?

8670

---

Where are oxygen analysers installed in cfbc boilers? What are their usual readings?

1542

---

In turbine, what does term CDP, NI, NH, HSSOC, means

2775

---

Draw symbols of the following :

1987

---

What is the basic difference between Modbus and CAN Open Protocols

6450

---

Turbidity analyzer working principle ?

1787

---

IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?

2400

---

Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.

2078

---

In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?

1873

---

Using your own examples solve a problem involving normal table. (experimental method and analysis)

1170

---

Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?

1777

---

How INtools is useful for routine Instrument maintenance?

2087

---

how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.

2311

---