Interested to Buy Any Domain ? << Click Here >> for more details...
why C.T secondary are rated 5A generally?
- 13 Answers
- 47595 Views
- ABC, Bhel, I also Faced
- E-Mail Answers
Answer Posted / puneet kumar
because current is measure by ammeter whose rating is up to
5 amp.(at secondry side of CT - CT is used only to reduce
the level of current at the measurable and safety level)
since we konw that CT has only 1 turn at primary
side becuase current is at higher value, to reducing it we
provide more turns at secondry side.. and this value can
measure by 5 amp. ammeter easily.
In power system, CT is used as protection device
also, which give signal to relay for operate under when
current become more than 5 amp.(at secondry side)
Therefore, CT secondry are rated 5A generally.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
i installed 100kva ups. what KVA genset they should provid in input side? plz any update formula or ans with reason.
what are inherent currents?
how to calculate percentage impedence at 75 deg C at normal tap
What are diffrent type of road taxes?
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
Define coil span?
How many types of electrical earthing are there?
whats the application of voltage regulation? and whats the voltage regulation's device?
What is the basic of DTH.
what is the common earth
what is the acceptable limit value for Desolve Gas Analysis/
how can we determine size of a cable by knowing the kw or current rating of a load?how can we calculate the resistance box of a slip ring motor?
Why using synchronising methed in DG's sets?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
