Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / hiren barot
Direct current or DC electric motors work for situations
where speed needs to be controlled. DC motors have a stable
and continuous current. DC motors were the first and
earliest motors used. They were found, however, to not be
as good at producing power over long lengths. Electric
companies found using DC motors to generate electric did
not work because the power was lost as the electric was
transmitted. Brush DC motors use rings that conduct the
current and form the magnetic drive that powers the rotor.
Brushless DC motors use a switch to produce the magnetic
drive that powers the rotor. Direct current motors are
often found in appliances around the home.
Alternating current or AC electric motors are used
differently based on what type of AC motor it is. Single
phase AC motors are known as general purpose motors. They
work well in many different situations. These AC motors
work great for systems that are hard to start because they
need a lot of power up front. Three phase, also called
polyphase, AC motors are usually found in industrial
settings. These motors also have high starting power built
transmit lower levels of overall power. AC power gets its
name from the fact that it alternates in power. The amount
of power given off by an AC motor is determined by the
amount of power needed to operate the system
| Is This Answer Correct ? | 19 Yes | 6 No |
Post New Answer View All Answers
How does HT work & Voltage required?
How CFL &T5 tube light glows?
Classify driling machines.
What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
What Is HO factor in power selection
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
the typical output of a solar cell is........
what is the use of sdf?
Briefly describe your ideal job?
what is the effect of vector group while phase sequence of a generator changes,whether the vector group changes or not
How to Make relay co ordination chart for a Electrical power distribution of a plant
1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.
In vapour absorption refrigeration machine fluids used are
What conditions are required for transformer to operate at low frequencies ?
