Interested to Buy Any Domain ? << Click Here >> for more details...
sometimes, eventhough the HV side of the transformer is
opened there is a voltage in LV side .How is it possible?
- 4 Answers
- 7202 Views
- I also Faced
- E-Mail Answers
Answer Posted / avd
I am not agree with you people. Residual magnetism can not
produce any emf. You need a variable flux or rotating
conductor to produce emf, which is not the case.
There will not be any voltage in sec winding if primary is
kept open.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
How a band pass filter is constructed?
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
what happen ehen synchronisation is done at below rated speed
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
What are the raitings of Mcb,mccb and Acb in detail ??
boiler is running in rankine cycle and deisel generator is....?
If anyone would like to know or practice for FEWA papers contact me on mohamedrashad2@hotmail.com Just completed the supervisor exam in April 2021
What is dielectric loss?
On Which Pressure PRV is operated.
Explain how you intend to work under pressure to meet up with deadline target?
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
