Interested to Buy Any Domain ? << Click Here >> for more details...
do we people experience any shock if we catch any one of
the three phases (R Y B)in air with out touching ground.
- 7 Answers
- 8435 Views
- I also Faced
- E-Mail Answers
Answer Posted / mother_ashok@yahoo.co.in
No. Current will flow only in the closed circuit. When we
are in air we don't have any earth contact and touching the
any ONE of the phase means we don't get any shock unless we
get any earth contact or we will touching any of the other
phase at the same time.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Define peak overshoot.
what ispositive, negative, zero sequence impedence?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
What is effect of over voltage and under voltage on ACB
wat is d diffr btw shunt coil and trip coil in VCB?
The inventer is a battery, but if lost current at home u will turn on the fan but the is AC and inventer battery is dc . Then how the fan was rotating. What device Or machine in fan converst the Dc power to Ac power
how load of a turbo generator can be increased
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
how to remover corona effect and hysteresis losses from contactor
Define piezo-electric effect?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
