what is the use of choke on tube light fitting
- 37 Answers
- 72208 Views
- Bhel, Dharma, HSBC, TCS, I also Faced
- E-Mail Answers
Answer Posted / moin
I think choke limits the current when current flows through
the ionized gas
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
how is the cable tray designed & how its total length is calculated for an Industrial plant Say for Ex. (500KW Motor Load)
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
how can found motors folt current ? how can disided circuit breakers caoicity and breaking capicity ?
How to calculate mf when meter equipment and meter are connected
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
1600 KVA ka transformer hi aghar lt side par 800A aur voltage 420 ho to HT side ki cable ki rating keya ho gi?
WHAT IS MEANT BY OVER EXCITATION IN GENERATOR TRANSFORMERS? DESCRIBE IT.
How to connect the chemical earthing and complete process tell me plz
how to failure indution motor insulation & how to improve heat in motor insulation
CAN WE CALCULATE THE NEGATIVE SEQUENCE AND ZERO SEQUENCE REACTANCE OF A GENERATOR USING ONLY ITS RATED VOLTAGE, KW, PF AND SYNCHRONOUS REACTANCE??? IF YES, THEN HOW??
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
why tertiary winding is used in transformer with diagram?
Why let through energy not considered for ACB breaker while cable sizing?
