Answer Posted / pavan kumar
power factor is the cosine of the angle between fundamental
component of voltage and current
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
I am abt to give IOCL intrv.Plz sir guide me for IOCL intrvw (Electrical).Which subject to be consider. questions are generally asked from which subject.Plz help me out.
What current flows in the transformer primary when its secondary is open?
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
Transmission through a short line depends on
How Can You Relate Power Engineering With Electrical Engineering?
What do you mean by dependent and independent voltage sources?
why on delay timer used for fully automatic star delta starter?
What are the types of excitation system?
before synchronizing an alternator,power factor is leading ,why?
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you