Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pradumn
grate
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
Explain why would some industries select pneumatics over hydraulic?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
sampile paper for dme in rrb exam
are BS, BSP, BSW threads same?
In a four-stroke diesel engine, In what engine exhaust valve will open?
i need to prepare for iocl exam.pls provide me the book names for apptitude section which include reasoning,numerical ability,logical deductions......
Enumerate the cause of pumps low delivery of water
Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?
Which country has the worlds most powerful tank?
I am presently working as marine engineer on ship & I wish to settle on land. So can you please suggest any short term course with 100% job guarantee?
What is a vee used for on the vee block?
What is IS standard in case of mode of measurement for ducting
Which welding process uses non-consumable electrodes?
As compression ratio increases, thermal n increases. How is thermal n affected by weak and rich mixture strength ?
What is the difference between Over Molding and insert molding ?
