why we +ve load distribution in 24v and -ve load
distribution in 48volt in the telecom sector.?
Answer Posted / ta
for above ans Mr.Aree Dewan you are out of the question
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
how do i commission a distribution transformer knowing all its ratings and transformation ratios?d
errection check list for transformer maintenance
How the setting of the vector surge relay shall be calculated when the relay is to be used for Grid islanding application?
Why in ESP Positive earthed
which of the following elements is not present in stainless steel
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
What are safety device in vcb and acb?
what is the effect of vector group while phase sequence of a generator changes,whether the vector group changes or not
What is ST and specify its range of voltage.
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
What will be the voltage impact on secondary side of two transformers with different vector groups when both voltages are compared.
how does a shunt reactor maintains the bus voltage???
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
how is control wiring coding is done in a CRP panel ?