Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between earth and neutral.
- 9 Answers
- 12495 Views
- DLF, I also Faced
- E-Mail Answers
Answer Posted / qwde
Wire connected to the juction of Star connected system is
known as Neutra wire.
This point or any equipements body are conected to earth
through earthing wire.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
why use phase displacement in transformer.and effect of phase displacement on transformer
our industries ht line so power fluctation(once drop of power please rectify causes
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
What are all present producing cost of Per KWH of various Fuel?
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
why using transformer and thyristor switch in 3 phase apfc panel
what are the tests comes under the type test, what tests comes under routine tests.
What can you contribute to the progress of our Company as an employee if you are selected?
Can Anyone suggest the Standards (IEC or IS) for selecting copper current density?
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
Why L.T.Cable voltage rating is 1.1kV,where as system voltage is 0.415kV?
How Can You Relate Power Engineering With Electrical Engineering?
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
