Answer Posted / sumit dhar
Dyn11:
D- Delta Connection in HV side. Notice the "D" is written in
Capital letter which means HV connection.
y- Star Connection in LV side. Notice the "y" is written in
small letters which means LV side
n- This represents that the Star side of the transformer is
connected to the ground with the neutral wire. If n is not
there, it means the star side of the transformer is unprotected.
11- represents 11'o clock which is 30 degree angle
other representations are
0- phase displacement is 0 degrees
6- represents 6'o clock position which is 180 degrees.
| Is This Answer Correct ? | 29 Yes | 7 No |
Post New Answer View All Answers
why only exciting current is shown not primary current in transformer???
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
I have iti elec, 1st aid, and 5 yrs experience in 7.5 mw power plant. Am i eligeble for 11kv license in telangana state..when, how to apply for that.?
Why can't we parallel the secondary circuits of two voltage transformers?
Importance of fault current in power transformers and how to monitor the same? How is it different from winding temperature?
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
What is the previous name of Cox's Bazar
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
Which power will flow first if we switch on a motor Active or Reactive? How?
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
what are all the components required to assemble solar panel other than pv cell?
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
Explain Energy and Power signals?
