Interested to Buy Any Domain ? << Click Here >> for more details...
where using the 0-20ma in feiled instrumentation? why its using?
- 4 Answers
- 7396 Views
- I also Faced
- E-Mail Answers
Answer Posted / sreenivasulu
because of getting the accurate results we using 0-20ma in
instrumentation instead of voltage
| Is This Answer Correct ? | 1 Yes | 13 No |
Post New Answer View All Answers
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question
Explain the working of an enraf level gauge.
I have completed B.E. Instrumentation & control in 2009. i have 3 year industrial job experience in chemical plant.now, I want to join M.E. in external. so, Plese say easiet way and good institute name.
what is interface level measurement.who can calibrate interface level measurement transmitter online
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
what is the difference between scaler and vector drive
How do bending tubing provide better measurement than using tubing fittings such as elbows?
What is solenoid valve? Where it is used?
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
How many interlocks at turbine? Plz explain briefly
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
what is the diffrence between pressure safety valve & pressure relief valve....pls
