Interested to Buy Any Domain ? << Click Here >> for more details...
why do we connect droop ct{in gensets}in y_phase only
- 2 Answers
- 8459 Views
- I also Faced
- E-Mail Answers
Answer Posted / sachin
Your quetion is wrong
bcoz,we connect droop ct in B phase only
R & Y phase gives sensing to AVR.
| Is This Answer Correct ? | 5 Yes | 8 No |
Post New Answer View All Answers
What is the formula of frequency ?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
What is the role of power pack in substation protection system?
what is the excess air in furnace
what is the function of impulse relay
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
i need to give section engineer (electrical engineer) for RRB. Please suggest some book
i have 3500 amp load and select current transformer and perches.how i calculate .please understand
How is the gain affected by the introduction of feedback in a control system.
why we are not giving the zone 1 trip command to the master trip relay
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
what is the use of static frequency converter and static excitation equipment? and where it is employed? for what?
how can we design robots
What is the difference between earthing,ground&nutral?
