Answer Posted / kapil n.bahadure
The current will flow in neutral when circuit have in
unbalanced condition in three phase system.The magnitude of
current & impedance valeu is not same then retern current
flow in neutral wire for circuit comleted.
The single phase system neutral is required for circuit
complete.when circuit comleting then current flow by
neutral wire.
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
What are the factor to be consider for CT selection in 132kV substation?
Difference between ac parallel circuit and ac series circuit?
What is the principal of motor?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
witch pump used in wtp
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
state working of halogen lamp?
HOW TO DESIGN THE body EARTH cable(Copper Conductor) size for 60KVA UPS?
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
what is cogging and crawling
how to electrically make connection to ferroli GN2N?
how to design the heater in temperature control unit to heat 50KL of water?
