a.)Ammeter and Voltmeter read rms value or avg. value ?
b.)What are symmetrical and Unsymmetrical faults?
Answer Posted / anil
ammeter and voltmeter always reads R.M.S value of the measurement only
and when comes to faults
symmetric faults: 3 phase faults
unsymmetrical faults:
1. L-L FAULT
2. L-G FAULT
3. L-L-G FAULT
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
various transmission tower like .,D tower ,K.C.O tower ,C.C.O tower,K.C.R tower ,C.C.R tower ,H.C.O tower in different tons.
low frequency protection why recomend?
How many types of oil using in H/T & L/T Oil Circuit Breakers. need Explenation ?
What is the working principle of MIG welding? and its out put Voltage?
i am going to correct power factor of 1600kw induction motor,when i calculate capacitance of capacitor it is three time more in star connection than delta. if motor is star connected which connection i shall adopt for capacitors and reason for adopt this connection
CBCT selection
what is reverse power relay brief explanation and in b/w where it is connected
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
If short circuit ratio is high is it bad or good for a machine then tell the reason...
In a flange coupling, the flange bolts are designed for
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
Define load factor?
how to make an earthing certificate
Define cuttoff frequency?