Interested to Buy Any Domain ? << Click Here >> for more details...
what is phase angle and how its generate moreever how we
measure the phasse angle?
- 1 Answers
- 4553 Views
- I also Faced
- E-Mail Answers
Answer Posted / siva kumar
Measurement of the time delay between two periodic signals. The phase difference between two sinusoidal waveforms that have the same frequency and are free of a dc component can be conveniently described as shown in the illustration. It can be seen that the phase angle can be considered as a measure of the time delay between two periodic signals expressed as a fraction of the wave period. This fraction is normally expressed in units of angle, with a full cycle corresponding to 360°.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How to calculate impedance volt in Transformer?
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
what is the method of earthing of a transformer using electrodes?
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
What is the suitable transmission voltage?
Testing report of Earthing of 3.15 MVa PTR.
why dimmerstate always connected in star connection? what will happen if it connected in delta?
What are the basic elements used for modeling mechanical rotational system?
What is vacuum circuit breaker.define with cause and where be use it device?
How to work E.L.C.B and how to connect in circuit.
which metal is use in shunt
What is Icu and Ics and what is difference b/w them. please tell me how to calculate a size of a copper bar for a system or a breaker... reply on... king.arish@gmail.com would be waiting for a logical answer.
what is the reqirred voltage in HT motor to get full RPM on no load test?
whate is the meaning of balance/unbalance,in stabilizers type
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
