Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS EDDY CURRENT LOSSES AND SKIN EFFECT LOSSES IN
ELECTRICAL ENGINEERING
- 1 Answers
- 4764 Views
- GAS, I also Faced
- E-Mail Answers
Answer Posted / ranjit singh
when the e.m.f. is induced in the winding ,then this e.m.f.
also induced in core of the transformer because winding is
put on the core and core is a magnetic material and due to
e.m.f. current flow in the core and heat is produced inthe
core ,
it is known as eddy current losses.
SKIN EFFECT -:DUE TO THIS EFFECT current is flow over the
surface of the conducter
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
how to calculate micom relay earth falt time and current sertting
can i connect the two phases of scott connected transformer,if not why?
from generating station If 400v LT line length is 1000m how much voltage is drop and how do i calculate it? which cable will be use for this line?
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
How are load losses and no-load losses measured at site in a DG set?
How to calculate of maximum demand if given 628kw, 785kva, 0.8 p.f.
what are the applications of PLC?
where solid grounding and where grounding through ngr done and why?
What is q factor?
