Interested to Buy Any Domain ? << Click Here >> for more details...
why we multiply 11 in High Electric supply?(eg.11KV, 33Kv,
330Kv etc.)
- 3 Answers
- 7189 Views
- I also Faced
- E-Mail Answers
Answer Posted / satish chaudhari
I think that It is due to the form factor which is 1.1 .
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
Define piezo-electric effect?
What are hrc fuses and where it is used?
what is high - pot test. what's its use?????
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
Define delay time.
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
How to run a three phase motor into single phase........
what are all types of cross section in AC cables?
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
draw singleline diagram of star to delta and dol starters
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
