Interested to Buy Any Domain ? << Click Here >> for more details...
why our indian system choose the 230 volt for single
phase&415 for 3-phase voltage,in forign side 110 volt is
used what is the difference
- 4 Answers
- 20470 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / virendra joshi
Basic rule of electricity is W= V*I now wattage would be
the rating of the quipment which remain constant means the
voltage is decrease then current will increase but if
frequency is increase current will decrease now as per this
in foreign the frequency is increase & voltage is decrease
so the required insulation level is decrease. in india the
voltage level is 230 & frequency 50.
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
what is inter connected dc generator?
What does a Bode plot tell you?
Define cut-off rate?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
How to maintain ac plant?
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
Usage of flywheel diode in relays
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
I have c license but I don't know eligibility of Max Kilo Volts under the electrical licensing board.
How can ou verify the size of conductor 50Sq.mm ACSR
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
What is difference between Sample test and Routine test in safety standard?
What will happend if given Vfd out put to step up transformer
What is a dominant pole?
