Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sukhraj sirsa
Instrumentation is the branch of engineering that deals
with measurement and control.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
why orfice is not used for main steam flow calculation
How to Calibrate Coriolis Flow transmitter in field
What is the procedure of calibration of Load cell?
what are the values of fuel flow rate in various places in boiler.
for oil & gas industries which zone is normally preferred? why? give its example?
plz send me general of ongc
what is interface level and how it is calibrate?
May I have a brief note above the voltage barriers? Whats is the purpose? Please mail me if you've operational details, mail id: rajkumar.diice@gmail.com
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
What is the diffrence between digital signal processing and discrete signal processing?
what would be the minimum flow rate that we can measure on rotameter..?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
why we are using drum level control valve air to close?
