why 400Hz is used for aircraft systems ?
- 14 Answers
- 49882 Views
- Cabin Crew, Jet Airways, I also Faced
- E-Mail Answers
Answer Posted / raina
400 hz is used in aircraft because this is the optimum
frequency. If frequency more than 400 hz used losses will
increase since most of losses increase with increase in
frequency and if lower frequency is used than size of the
component will increase.so 400 hz is the optimum frequncy
which provide the balance i.e. for the given size of
component or equipment losses is not that much high.
| Is This Answer Correct ? | 74 Yes | 6 No |
Post New Answer View All Answers
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
why swityard is necessrry requirement in any bis power distributin systems?
In radial network the source is fed from 1 end both ends at central
Explain the experiment on ward leonard method of a speed control on a dc shunt motor with an suitable circuit diagram.
How to calculat the ratio of HT\LT in energy meter
what the function breaker failure scheme, how is it operated
how is the connection of a 3 phase ct trivector meter done on a pole mounted transformer
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
Difference between drift current and diffusion current?
what is DRP panels?
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
Can we use a absolute encoder to show rpm of a motor ? what about the condition when power is off ? what is difference if a incremental one is used ?abanirout@gmail.com
why effective resistance should be more than static resistance in transmission line?
