At a family reunion were the following people: one
grandfather, one grandmother, two fathers, two mothers,
four children, three grandchildren, one brother, two
sisters, two sons, two daughters, one father-in-law, one
mother-in-law, and one daughter-in-law. But not as many
people attended as it sounds. How many were there ?
Answer Posted / shah alam
in the family as i think there should be an old man(a) and
his wife(b) and the have a son(c)and a daughter in
law(d).and this couple (cd)have one son(e)and two
daughters(f,g).
| Is This Answer Correct ? | 20 Yes | 3 No |
Post New Answer View All Answers
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
When can we take Neutral as common neutral link?
difference between high and low impedance BUS BAR relay??
why high speed tripping relay will be used in tripping circuit why not normal relay
difference between the applicability of nortons and thevenin theorem
HOW TO WRITE A QUENTION ANSWER? I MEAN SHORT OR LENGHTHY ? OR FROM THE BOOK AS BOOK..... SOME TIME WE GIVE A ANS FROM THE BOOK AS LIKE BOOK ND WE GET MINIMUM 60% MARKS OR MORE THEN....... THEN HOW TO FILL THE Q-PAPER?
What is current & voltage ? Voltage perform at any load without current or not?
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
which VFD is better ( LT or HT)
Comment on the working principle of operation of a single-phase transformer.
What does ampere turns shows?
oltc of a transformer, how it works? and what are the equipment consist of describe briefly?
What is Surge Capacitor? Why it is use in Generator Circuit Breaker?
Can clean earth cable be considered as low current cable