Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mahadev
I think this is the AVR
AVR- means Automatic Voltage Regulator.and it is used in
transformer.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
what is lumped and distributed elements?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
how to calculate power consumption in slip ring motor at different step
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
what are the principles of a booster converter?
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
how does directional relay work incase of ac ?
What is synchro?
How to calculate the sag of OPGW during stringing???
How to Preparation of online test
how to operate and maintenance of 1500 kva diesel generator set
What is the practical way to calculate the cable size for known ampere load?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
block diagram of 2 ups system connected in hot stand by mode?
