Answer Posted / kiran h mehta
The trip circuit supervision relay is used to monitor
tripping circuit healthyness.It confirms that the breaker
will trip in case of fault on the operation of relay on it.
The circuit is wired through resister and a tripping coil .
Shortly is called as TCSR.It has three coils in it one of
it is flag relay and if trip coil opens , flag indicate
unhealthyness of the tripping circuit.
| Is This Answer Correct ? | 19 Yes | 0 No |
Post New Answer View All Answers
What are the weight of 800KV DA,DB and DC type tower ?
what will be d.g. capacity to cater together for 14hp A.C. load & 3kw lighting load
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
What is Traction? 1KVA Alternator, How much urrent taken?
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
whatare the disadvantages occur,if the form factor of transmission will not be equal to 1.11
How DC earth leakage currents can be reduced ?
What is an alternator impedance value?
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
How to Preparation of online test
In AC if the direction of current keeps reversing every half cycle, how does it propogate through the transmission lines?
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
why single CT used in DOL starter power circuit?
