Interested to Buy Any Domain ? << Click Here >> for more details...
why CT ratio stand for 50/5, 100/5, 25/5.
- 11 Answers
- 68784 Views
- ABB, Ramky, I also Faced
- E-Mail Answers
Answer Posted / wasif
50/5 means that if 50 amps currnt will flow in primary then
5 amps current will flow in secondary. Actually it is the
transformation ratio of the ct Ip/Is
| Is This Answer Correct ? | 57 Yes | 13 No |
Post New Answer View All Answers
how is the incoming cable size calculated for a given current rating of a panel??
v/f drive basic princeple
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
Is Transol transformer oil comparable to nynas nytro libra?
What is the difference between resistance grounding system and resistance earthing system?
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
What is Traction? 1KVA Alternator, How much urrent taken?
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
how to calculate cable size in diffrent loads?
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
What is the function of a neutral reactor.
what do w do when the output of generator is fluctuating?
