Answer Posted / shaik dawood
I Thing this type of floating neutral system used in
aeropline,Further Neutral of the Flight wire will be
connect with flight body. Because There is no return path
to this current.It means the Return path current will be
neutralized with air atmosphere.(Dear Friends If its wrong
plz clarify dawood_ee@yahoo.co.in)
Is This Answer Correct ? | 3 Yes | 8 No |
Post New Answer View All Answers
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
What is the implications when 600 hp motor is started when the unit is running with Transformer of capacity 1500 KVA and DG set of 1000kva
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
Please elaborate th´evenin’s theorem?
How to test IR testing & magnetic balance test
which is better to use svc or synchronous condenser why ?
What is formula calculation size cable wire ?
can the measured percentage error during calibration of single phase energy meter be negative?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
What will be advantage if we put some load in neutral of grounded star transformer & loadshortcircuit current,rated current of cable & MCB with example?
What is meant by cold loop test in instrument
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?