Interested to Buy Any Domain ? << Click Here >> for more details...
What is dew point corrosion in HRSG Condensate Reheating
tubes?
- 3 Answers
- 7890 Views
- I also Faced
- E-Mail Answers
Answer Posted / kumar
Hi Rathnam, Dew Point Corrosion in Heat Recovery Steam
Generator(Boiler). In this HRSG one Condensate Reheating
Tubes module is provided. For this module we will give DM
water supply as a Feed Water supply. This DM water will be
at Atmospeheric temperature. To increase this water
temperature we will pass this water into CRH tubes. After
CRH the temperature should be mini 150deg.C. Unitll this
temperature reaches this water will Re-circulate itself by
Re-circulation pump. Afther getting 150deg, it will go to
Boiler Drum. In HRSG write-up, they written as "To avoid
Dew point corrosion in CRH, we have to heat the water upto
150deg".
Go it naa?
thank you
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how the material no. 2062 will mild steel of desity 7.85? what are the other codes?
What is higher IMP or BHR
Gegger is used in foundry for the purpose of____________
One litre is equal to ________cm3 ?
HOW TO CALCULATE THE FILTER ELEMENT AREA FOR VISCOUS FLUIDS IN CASE OF PLAETED METTALIC FILTERS
how many types of sensors used in a air handling unit
Wasco Interview 1-the type of transducer that convert mechanical movement into a voltage 2-pump 2500 psi and 100 MG select it 3-modes of heat transfer 4-the difference bet PSIA and PSIG 5-the function of relief valve and no return valve (check valve ) 6-types of bearing general catogires 7-function of bearing 8-compressor surge 9-pump cavitation 10-define critical speed 11-compression ratio decease volumetric ratio ........... 12-using inter-cooling in multi stage compressors to ....... 13-using cascade system in refrigerator function ? 14-define performance and efficiency .
What is the seal packing gland for turbine?
which power station plants r more efficient? which is less? which is most expensive and which is cheapest?
how to calculate steam velocity on tg i/l ?
What is a vee used for on the vee block?
Enumerate some trouble of fuel injection valve
Give an introduction to bourden pressure gauge?
What is the importance of thermostat in the cooling system of an engine?
why does bitumen heated from top side bt not from bottom side€
