Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pragati
power factor is defined as the cosine of angle between
voltage and current.
From the power triangle, we can define power factor as the
ratio of active power and apparent power.
It is also defined as the ratio of resistance and impedance.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
Write the analogous electrical elements in force current analogy for the elements of mechanical translational system.
how to find the voltage's of a transmission line plzz help with pictures i am not able to understand
how to calculate maximum current
How could I get a certificate of competency as Electrical Supervisor? I have completed By BTech in Electrical this year(2012) for VJTI Mumbai Maharashtra. Is it compulsory to be produced while joining?
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
why normally Generator rating are between 11Kv to 22Kv?
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
pls tell me function of closing coil of A.C.B.
