Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nithya
generally electricl resisitance should be a 2 ohms. suppose
u are in a building the individual ohm is 1.2 ohm. and group
should be a 0.8 ohm.
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
what are the advantages and disadvantages of oil filled cables over XLPE cables
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
Why a Permanent Magnet Generator has higher frequency as compared to frequency of main alternator?
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
HOW TO CALCULATE EARTHING SIZING?
What is Primary And Secondary Injection Test of Relay and Other Electrical Devices. How IT is carried out.
what is load despatching
Whata are the types of Cables?
What is thresh hold value of current?
What is measurement?
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
