Answer Posted / deepesh k v
a low postulated by Georg Ohm.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
what percent do you derate your copper wire when you change from copper buss to copper wire
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
Explain the operation of grid connected central solar inverter ?
What Maximam Gap Taibaar & Bush
BRIEFLY EXPLAIN THE STORAGE CLASSES AND THEIR TYPES IN C
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
What is the RME and explain the full form and what is the RME work?
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
how to check avr of dg set of 125kva
what is the excess air in furnace
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
Define cuttoff frequency?
