Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / shaikh
To calculate bus voltage, currents, Mwatts, MVar and power
factor. The results will indicate abnormal conditions of
overvoltage, undervoltage, overload of transformers and
cables.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
difference between power surge and switching transient
how can maintaince the acb contactor moveing and fixing kit
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
what is physical distance of isolator to VCB in 33/11kv sub stations
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
What are the three constants associated with a steady state error?
EXPLAIN WHY THE SURGE CURRENT RATING OF AN MCCB OR CIRCUIT BREAKER DECREASES WITH INCREASE IN THE RATING OF MCCB OR CIRCUIT BREAKER.
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
give me atleast four differences between circuit and network
why the check zone and main zone are used for Busbar Protn. scheem?
