Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / surya659
The primary function of the bushing is to provide an insulated
entrance for the conductor into the tank of the transformer.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
how to calculate the lightning arrester conductor @ no of earth pits required
Can we convert off line transformer to on line transformer
Why syn. Generators are used for the production of electricity?
Why efficiency of generator is higher than motor at a particular load?
What is the use for cable entry in control room?
What is the use of Surge Capacitor in LAVT?
what is the safety of voltage power transformer(2250KVA0
kindly send me 11KV MV motor differential protection procedure by primary injection method.
What do you mean by reach and reach the point of the relay?
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!
Why is better to have a minimum ceiling voltage of 250% than 160%?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
