Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sudhir prajapati
Its a one type of feedback system. PID controller try to
correct the error between a measured process variable and
desired set point by calculating and then it generates the
corrective action accordingly
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
please tel me the calibration of pneumatic controler.
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
How digital input and digital output 's are working in dcs
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
Explain about safety integrated level protection? . How it was differ from other protections ?
how to relay switch sense the fault?
How hart protocol can be connected with control valves?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
What is voltage regulator?
TEMPERATURE VARIATION FOR FREQUENTLY.
what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
