Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jignesh kadia
yes, motor will run with lesser torque & speed..but after
some time it's get overheated because of they run under
exited condition.the emf not much produce to rotor cause
rotate at rated speed so that humming produce in it. the
losses are produce in motor and it's get overheated.. and
motor will burn out..
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is diff. between earthing grid,earthing mess, earting grid?
how to check three phase motor torque value?
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
"TRANSFORMER MODELING AND ANALYSIS" MEANS WHAT AND WHICH TOPICS U READ IN THIS
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
What are the weight of 800KV DA,DB and DC type tower ?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
Where is servomechanism used?
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
