whether inrush current for lamps or capcitors should be
considered cable sizing to feed that load.
Answer Posted / sathiarajan
Its must for the capacitors. If the frequency of charging &
discharging is increased it will take & deliever a huge
current at all the charging & discharging cycles. So the
cable will get hot quickly, if it is not reated properly.
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
why fractional pitch winding generally used in alternators?
what is mean by PIR in circuitbreaker and give me detail of that?
What is βpuβ in ee?
In convertor can we use rectifier thyristor in place of invertor thyristor with explain.
what is effect of length of air gap on performance of dc motor and generator?
if we run a 3 phase machine on two phase what will happend??? given answer with solid reason please
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
What is advantages of VSCF wind electrical system?
. What is Electrical Life & Mechanical Life of Circuit Breaker? 2. What is Electrial Life & Mechanical Life of Magnetic Contactor? 3. What is RCD, RCCB & RCBO? 4. What is the Between defferance of RCD, RCCB & RCBO?
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
Sir 33kva 2 transformer load 900 amp calc 1800 amp mana jayega
What are the basic component of a cro?
What type of a DC motor would you use for a lift?
132/6.6ππ πππππππππππ πππππππ πππ πππ πππππ πππ πππππππππ. πΈ'ππ πππππππ πππππππππππ ππ 6.6ππ/415π πππ πΈ πππππππ πππππππ ππ ππππ πππππ πππ ππ ππ 13/6.ππ πππππππππππ?? πΈπ π½π.. ππππ π ππ’??
Explain the fundamental difference between emf (electro motive force) and pd (potential difference) ?