Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / deepak kumar behera
Instrumentation is the branch of engineering that deals
with measurement and control of process paramiters.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
what is piezoelectric transducer?give an example in power plant n state its principle?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
Why boiler chimney area oxyden sensor fixing?
Manipulation of dead wt. tester double piston type.
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
what is the process to make control schematic ?
how can use ram
what is the reason while warning lamp is on while the engine is cranking?
Why ac supply load cell is used? Can we use the dc supply load cell?
What are the interlocks we have to check during the start up of LP/HP compressor?
How we connect a instrument with ground, Give brief explanation with help of diagram?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
what is the difference between profibus and controlnet networking.
