Interested to Buy Any Domain ? << Click Here >> for more details...
what should be the distance of vibration sensor & to the
point where vibration to be measured Ex turbine axial
displacement
- 3 Answers
- 8071 Views
- I also Faced
- E-Mail Answers
Answer Posted / deepak kumar behera
The distance of vibretion sensor and the piont where the
vibretion is to be measured is should be 1.5 mm.
| Is This Answer Correct ? | 2 Yes | 9 No |
Post New Answer View All Answers
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
why I need valve guard and whats different between guard and positioner ??
What are different types of cable?
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
when a magnet is heated?
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
Differentiate between ultrasonic flowmeter and radar type flow meter
how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
