1)we r having one problem .one dry type
transformer(6.6KV/433V)is taking high magnetizing current on
delta connected HV side of "U" phase when compared to other
two phases.could any body tell the reason why it is happening?
2)why CT secondary side protection core has got higher
winding resistance when compared to that of metering core of
same CT?
- 2 Answers
- 4383 Views
- I also Faced
- E-Mail Answers
Answer Posted / tanvir s.
Answerin ur 2nd query:
As we kno the flow of current is inversely proportional to the the resistance. Hence a lower resistance winding on the metering core of the CT would ensure a sensitive/accurate current(ampere) reading. Following the same principle the protection core has high resistance to limit the flow of over current and step it down to the calibration of the metering side.
Pls feel free to correct me if i am wrong or not clear
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is the difference between isolators and electrical circuit breakers?
please explain how to do 'pole drop test' on generator?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
What is the working principle of MIG welding? and its out put Voltage?
How to calculate impedance volt in Transformer?
In radial network the source is fed from 1 end both ends at central
operation of protection relay watchdog contact?
What is the formula to calculate the rating of a three phase air circuit breaker
What is the mechanism of WTI
What do you mean by Stimulastion Test in Diesel Genarator / Why & when it's conducted ?
what is the need of starter in tube light and what type of starter is used in that?
What is phase cross over frequency?
