how we can convert 3 phase to single phase without using any transformer
- 8 Answers
- 10675 Views
- I also Faced
- E-Mail Answers
Answer Posted / pillay
I believe all three answers are correct but I can add one more.
If you don't want to use transformers than connect an appropriate
3 phase motor to a single phase alternator and run the motor the
out put from the generator would be single phase.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What are the commonly used schemes for the bus zone protection?
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?
132/66kv sub-station procation ?
how to calculate the settings for shaft ct protn in hydro generators
if a number of plc s are there then how many modbus to be used
Why do we perform an open-circuit test and short-circuit test on the transformer?
difference between ac series and parallel circuit
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
What is the tube exial fan?
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
How do we calculate the Out put voltage of generator, after the excitation is being given?
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
what is there inside an inverter and how it works?
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
